Fastener Products

Product Details

Slab Only Anchor PDF Type

For hollowcore precast concrete slab・semi-precast concrete slab / Internal cone driving type
  • Anchors for hanging bolts, hollowcore precast concrete slab and semi-precast concrete slab.
  • With a specially shaped flange, fully threaded bolt (W3/8) can be fastened sufficiently.
  • By marking two places on the head, it is possible to visually judge whether the embed. depth is 20 mm even after construction.
  • Installation completion can be visually confirmed by using a specialized setting tool.
[Application]
Installation for Pipe Hanger / Light Gauge Steel Framing / Duct / Cable Rack Hanging[br][span class="red"]※Cannot be used for cast-in-place concrete[/span]

❶Drill a hole
●Make sure that the drilling depth is 20mm according to the regulation.
●If it is drilled deeper than 20 mm, it may damage the PC steel wire or penetrate the skeleton and may not show sufficient strength. (See the figure below)
●In the case of a semi-precast concrete slab, it cannot be applied to the thin-walled part (shell part) before concrete is placed and hardened.
※The strength data of the base material can be downloaded from our website.
❷Clean the dust
❸Hammer the anchor
❹Fasten the appropriate size threaded rod or threaded bolt into the anchor

PDF Type

強度表をPDFで開く
Unit:mm Unit:kN
Thread D Embed. depth Max. load
Semi-precast concrete slab/Fc=50N/mm2 Hollowcore precast concrete slab/Fc=40N/mm2
Vertical 45 Degrees Diagonal Vertical 45 Degrees Diagonal
W3/8 12.0 20 14.0 12.0 11.0 9.0

PDF TYPE: STEEL / TRIVALENT CHROMATE COATING
サイズ表をPDFで開く

Open chart in PDF

Unit:mm Unit:pc
Thread Item no. D L dk Drilling
diameter
Embed. depth Drilling depth Qty・per
Box Carton
W3/8 PDF-3020 12.0 27.5 12 22.0 7.5 12.5 20 20 100 600

【Drilling】
Drill Bit with a Stopper [PDF-12.5×20SDS]
Drill Bit with a Stopper [DNZ-12.5×20SDS]
Drill Bit with a Stopper + Installation Tool [PDF-3020DH]
※For Slab Only Anchor only
Drill bit + driving holder set product
・After drilling
Cover the drill bit with a driving holder
Hammer in the anchor
【Cleaning】
Dust Pump [P Type]
【Hammering】
Anchor Hammer [AH Type]
Designated Setting Tool [PDF-3020H]

Designated Setting Tool
[PDF-3020HSDS]