・Press the drill point vertically on the place to be installed, then use a power tool to press and slowly rotate the screw.
●Please select the suitable product after confirming the thickness of the fixture.
●Please follow the size shown in the catalog to choose a recommended screwdriver bit.
●Please install at the rotation speed according to the size.
●Install the screw vertically to the fixture.
●Stop the rotation immediately after tightening is completed. Excessive torque can cause problems such as instability in the product fit and head skipping.
Working length explanatory diagram
In order to securely fasten the Drill Screw, the thread must completely protrude 3 pitches from the base steel plate. Therefore, the max. working length should be calculated by the length below the neck (L) -the length of the drill point (Ln) -3 pitches, and then select the suitable drill screw based on the working length.
※Caution: When installing the Drill Screw, it may not be possible to secure the specified working length depending on the condition of the jobsite. Please use it after checking the actual situation of the site.
サイズ表をPDFで開くOpen chart in PDF
| Unit：mm | Unit：pc | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| d | Item no. | L | (b) | Recommended board thickness |
Lg1 | Lg2 | Ln | Head | Recommended screwdriver bit |
Qty・per | |||
| dk | k | s | Box | Carton | |||||||||
| 5.5 | HEXL-5.5×38 ◆ | 38 | 22 | 6.0〜12.0 | − | 19.0 | 16.0 | 11.0 | 5.4 | 8.0 | KTB-8 | 300 | 3,000 |
| 5.5 | HEXL-5.5×55 ◆ | 55 | 39 | 6.0〜12.0 | − | 36.0 | 16.0 | 11.0 | 5.4 | 8.0 | KTB-8 | 150 | 1,500 |
| 5.5 | HEXL-5.5×70 ◆ | 70 | 54 | 6.0〜12.0 | − | 51.0 | 16.0 | 11.0 | 5.4 | 8.0 | KTB-8 | 100 | 1,000 |
Steel Anchors 
Chemical Anchors 
Other Anchors 
Wall Anchors 
Roof Anchors 
Core Drill Bits 
Drill Bits 
Setting Tools 
Techno Testers 
Infrastructure Anchors 
